Sensors · circuits · ESP32 · Builder programme
Smart Systems Builder
Go from loose components to one connected device that senses, controls and reports.
Programme overview
Know the starting point and finish line.
For someone who wants to wire, measure and debug a device—not only copy an Arduino sketch.
- Duration
- Typical plan: 10 weeks
- Format
- 20 guided studio sessions
- Starting point
- Beginner route available; foundation skills can shorten the ramp-up
- Programme fee
- ₹8,999
Project hardware is priced separately from the agreed bill of materials. Your schedule, payment plan and total cost are confirmed in the written build brief before enrolment.
A water-level monitor and pump-control prototype with automatic and manual modes, a phone-friendly status screen and enclosed electronics.
Build sequence
01
Measure before wiring
Use a multimeter, read a circuit, choose resistors and find power or connection faults.
02
Make the device sense
Read water level, temperature, light or distance sensors and distinguish useful readings from noise.
03
Make it control
Drive indicators, buzzers, motors and relays while keeping logic and load power separate.
04
Connect it
Program an ESP32, expose device status and send commands from a simple local dashboard.
05
Build the capstone
Assemble, enclose and repeatedly test the complete monitoring and control system.
Completion
Finish with work you can show and explain.
Attendance alone does not complete the programme. The build and its record must meet the stated test.